Substations are unmanned, spread across whole service territories, and increasingly targeted — from copper theft to sabotage. RBtec turns the station fence into a zoned detection layer reporting through existing SCADA, documented for CIP-014.
A utility may operate hundreds of substations, and almost all of them are unmanned. The first sign of an intrusion is often an outage, a SCADA fault, or damage found by the next crew visit. Three problems come up at almost every station:
NERC CIP-014 applies to transmission stations and substations identified as critical to the bulk electric system. It requires a documented risk assessment, an evaluation of threats and vulnerabilities, and a physical security plan that responds to them. CIP-006 adds physical security controls around BES cyber systems, and IEEE 1402 provides engineering guidance for substation physical security.
None of these standards name a specific technology. What they expect is a deliberate, documented detection and response layer. Perimeter intrusion detection on the station fence is one of the most common measures utilities put in their CIP-014 security plans, because it produces a timestamped, zoned alarm the utility can act on and show an auditor.
The practical answer is to make the existing fence the sensor. A sensor cable mounted on the chain link detects cutting, climbing, and lifting at the moment it happens, and divides the perimeter into zones so operators know which fence line is being attacked. The alarm lands as a dry contact in the station RTU and travels to the control center over the SCADA path the station already reports through. Camera call-up on the alarmed zone gives operators instant verification.
The sensor cable mounts on the existing fence fabric, the processor sits in a small enclosure at the fence line, and the output wires into the station RTU as a dry contact. A security integrator typically completes a two zone station in a few days, with the station energized and in service throughout.
Fleet estimating is close to linear: one processor package per station, plus cable to match the fence length. The same design, alarm mapping, and spares repeat at every station, which is what makes a rollout across a whole service territory manageable.
IRONCLAD turns the existing station fence into a zoned detection barrier.
RaySense fiber sensing covers large transmission yards and is unaffected by EMI.
Alarms land as dry contacts in the station RTU and travel over existing SCADA.
PulseVi 3D LiDAR watches gates and open approaches without touching the fence.
One detection architecture that scales from a single station to a whole fleet.Passive sensors mounted on the existing fence, installed with the station in service.A documented, testable detection measure for CIP-014 security plans.Per zone sensitivity tuning that separates weather and wildlife from real attempts.We’re here to help. Whether it’s a quick question or something more complex: no pressure, just answers.
Real deployments with the problem each site faced,
what was installed and how it performs.
RBtec delivers innovative perimeter security solutions trusted worldwide. With over 5,000 systems installed in 57 countries, our products combine reliability, cost-effectiveness, and user-friendly design for any site size or risk level.
